Low-cost LCD-bias generator uses main microcontroller as control IC
Control a buck-boost switch-mode regulator with the same microcontroller that sends data to an LCD.
Tom Hughes, Dannemora, Auckland, New Zealand; Edited by Martin Rowe and Fran Granville -- EDN, November 26, 2009
LCD circuits often require a –10V voltage at 2 to 15 mA to bias a graphics-LCD-driver IC. You can usually accomplish this task with an external charge-pump IC, such as Maxim’s ICL7660, but that approach adds cost to the design. Instead, you can control a buck-boost switch-mode regulator using the same microcontroller that sends data to the LCD. In addition, you can sequence the power rails under software control, as some types of LCD controllers require.
The circuit includes IC1, an Atmel Attiny15 microcontroller (Figure 1), which provides regulation with 200-mV-p-p ripple at a 30-mA load current when supplying –10V. Listing 1 lets you download the source code, which uses only 4.8% of the total CPU time to achieve the stated regulation, even with a relatively low-speed clock frequency of 1.6 MHz.
|
To minimize CPU time, the software uses the 8-bit on-chip PWM (pulse-width modulator) to drive Q1. With the on-chip ADC in free-running mode, the microcontroller generates a hardware interrupt with a period of 7.69 kHz. The interrupts have one drawback: If they stop, the circuit can go out of regulation. Thus, you must take care when using interrupts with long processing times. The Attiny15 uses an on-chip, 16× PLL (phase-locked loop) to drive the PWM timer. You can achieve a PWM carrier frequency of 100 kHz, which allows the use of a relatively low-capacitance filter capacitor, C1.
Two constants in the source code let you alter the bias voltage of the circuit’s output voltage. These constants employ basic buck-boost-converter theory (Reference 1). The following equation defines the maximum 8-bit constant, or threshold, that the ADC reads on the chip: 51.2×{VCC–[(VCC–VMAX)/(R4+R5)]R5}, where VMAX is the maximum desired output voltage and VCC is the supply voltage. To achieve optimum operation, increase the PWM signal’s duty cycle when you need higher voltages. Use the following equation to determine the 8-bit PWM’s value: 255–VOUT/(VOUT–VIN)×255, where VOUT and VIN are the output and input voltages, respectively. In practice, however, if you keep the current at less than 2 mA, this requirement is less important.
The circuit can deliver currents that Q1’s collector current predominantly delivers. This current is the peak output current that the circuit can safely deliver. The following equation calculates the current: IOUTMAX=(VIN×0.08)/VOUT, where IOUTMAX is the maximum output current. If your design needs higher current, then substitute a BC327 for Q1. Additionally, the inductor should have a maximum rms (root-mean-square) current value of at least twice the peak output current and preferably be a low-ESR (equivalent-series-resistance) type to maximize circuit efficiency.
| Reference |
|
