1.5V battery powers white-LED driver

Edited by Bill Travis

Steve Caldwell, Maxim Integrated Products, Chandler, AZ -- EDN, September 30, 2004

Although white LEDs are common in a variety of lighting applications, their 3 to 4V forward-voltage drop makes low-voltage applications challenging. Charge pumps and other ICs are available for driving white LEDs, but they generally don't work with the low supply voltage of 1.5V in single-cell-battery applications. The low-voltage circuit of Figure 1 provides a current-regulated output suitable for driving white LEDs. The boost converter, IC₁, can supply load currents to 62 mA with input voltages as low as 1.2V, making it suitable for use with a 1.5V, single-cell battery. Because a white LED draws negligible load current until the output voltage rises above 3V, the boost converter can start with input voltages as low as 0.8V.

By deriving feedback from a high-side current-sense amplifier, IC₂, the circuit allows current regulation without sacrificing efficiency. IC₂'s 1.8-MHz bandwidth also eliminates instability in the feedback loop. IC₂ amplifies the voltage across R₁ with a gain of 20. This high gain boosts efficiency by enabling use of a small-valued current-sensing resistor. You can calculate the value of R₁ from the desired output current: R₁=1.235V/(20×I_OUT). For 1.5V input and 62-mA output, the circuit efficiency of Figure 1 is approximately 80%. Zener diode D₁ provides overvoltage protection at the output. When the output voltage rises above the sum of the zener voltage (V_Z) and IC₁'s 1.235V feedback voltage (V_FB), the feedback voltage (Pin 3) rises and causes IC₁ to stop switching. Thus, for an open-circuit output, the output voltage is regulated at V_Z+V_FB.

Check out our Best of Design Ideas section!

Talkback

» Submit Feedback

• 
  

  
  

  I got another circuit on
  control7.net/electronics/single_cell_LED_flasher.html
  and it works

  
  

  
  

  
  Russell - 2009-11-4 12:53:00 PDT

• 
  

  
  

  I got another circuit
  control7.net/electronics/single_cell_LED_flasher.html
  and it works

  
  

  
  

  
  Russell - 2009-11-4 12:52:00 PDT

• 
  

  
  

  I want christmas lights without wires! Is it possible to have an individually powered bauble which will last over christmas?

  
  

  
  

  
  David Smith - 2004-11-12 11:16:00 PST
» Submit Feedback

• Resource Center
• Browse Categories
• Browse Companies

Featured Company

• Rohde & Schwarz

  

  Rohde & Schwarz is an independent group of companies specializing in electronics. It is a leading supplier of solutions in the fields of test and measurement, broadcasting, radiomonitoring and radiolocation, as well as secure communications... more

• Agilent Technologies

  Agilent Technologies Inc. (NYSE: A) is the world's premier measurement company and a technology leader in communications, electronics, life sciences and chemical analysis... more

---

Most Recent Resources

• Atmel's QTouch Library 2.0
• The Impact of Digital Oscilloscope Blind Time on Your Measurements
• LTE-Advanced Technology Introduction
• FREE Webcast: Demystifying TD-LTE: A separation from LTE FDD
• Near Field Communication (NFC) Technology and Measurements