High-current supply uses standard three-terminal regulator
Edited by Bill Travis
I Hakki Cavdar, Karadeniz Technical University, Trabzon, Turkey -- EDN, July 22, 2004
Voltage-regulator design for high output currents can be a critical and difficult task. Although voltage regulators with 1A maximum output current are simple to design, thanks to 78xx three-terminal voltage regulators, at output currents higher than 1A output, problems arise. For high output currents, voltage regulators usually use parallel-connected power transistors. The design of the operating points of these power transistors is a difficult task, because the transistors need critical power resistances at the collector and the emitter to set the dc operating point. Both the power transistors and the power resistors dissipate high power, so the design needs heat-sinking. This Design Idea implements a simple voltage regulator that delivers high output current. The basic idea is to parallel-connect multiple three-terminal regulators. These 78xx regulators each handle 1A and are available in 5, 6, 8, 9, 10,12, 15, 18, and 24V versions. In Figure 1, two 7812 regulators are connected in parallel.
The two 7812s operate independently, and each delivers a maximum of 1A. D1 and D2 separate and isolate the two regulators. The output voltage is the regulator's nominal output minus a diode drop: VOUT=VREG–VD. The output voltage of the regulators is the specified value if the COM pin connects to ground (0V). To increase the output voltage of the circuit in Figure 1 to the desired value, the COM pin must connect to a voltage point one diode drop above ground. C, C1, and C2 are filter capacitors. Figure 2 shows a voltage regulator that uses 20 7812s and delivers 20A. All the diodes are 1N4007 types. C=47,000 µF, and all the numbered capacitors have a value of 4700 µF. The 7812s all connect to a heat sink that a small fan ventilates. You can expand the concept of this Design Idea to hundreds of amperes.
Check out our Best of Design Ideas section!
-
can i connect the all the com of the regulators to ground without the diode D
chong - 2009-5-7 06:53:00 PDT -
Great circuit but what is the R1 for and value?
Ron - 2009-18-4 11:50:00 PDT -
Dear G.Domingo: Thank you for your comments. All the diodes may be selected 1N4001, instead of using 1N4007. You are right, max reverse voltages are 50 V and 1000 V for 1N4001 and 1N4007 erspectively. So, 1N4001 is enough for this application.
Dr. I. Hakki Cavdar - 2006-22-3 00:23:00 PST -
For Diodes D,D1 and D2, instead of using 1N4007, you can just use 1N4001. The diode 1N4007's maximum voltage is 1000 Volts which is an overkill for this purpose since the 78XX series regulators has only up to 24 Volt variants. The 1N4001 maximum voltage is 50 Volts so it would suffice. A little savings on cost. Nice Diagram.
Glenn Domingo, ECE - 2006-21-1 08:49:00 PST -
Figures 1 and 2 refer to the 78L12 devices. The 78L devices (eg LM78L12ACZ) supply a maximum of 100mA whereas the 78 devices (eg, LM7812CT) can supply upto 1A.
Dr Graham Seed - 2004-6-10 07:30:00 PDT
