Butterworth filter has adjustable group delay
Edited by Bill Travis
William Stutz, Maxim Integrated Products, Sunnyvale, CA -- EDN, August 8, 2002
The Sallen-Key realization of a 5.25-MHz, three-pole Butterworth filter has a gain of 2V/V and can drive 75Ω back-terminated coax with an overall gain of 1 (Figure 1). Used to reconstruct component-video (Y, Pb, Pr) and RGB signals, this filter has an insertion loss greater than 20 db at 13.5 MHz and greater than 40 db at 27 MHz (Figure 2). Like the antialiasing filter before an ADC, this filter removes the higher frequency replicas of a signal following a DAC. To preserve quality in the video waveform, you should minimize group-delay variations in the filter and any group-delay differential between filters. That requirement mandates a means for adjusting the filter's group delay without affecting its bandwidth. In Figure 1, the addition of R2 in series with C1 and R1 creates a lag-lead network.
Keeping the sum of R1 and R2 constant and equal to the original R1 value preserves bandwidth by preserving the dominant-pole frequency. Increasing the R1 value, on the other hand, introduces a "lead" term that lowers group delay by reducing the rate of change in phase. For R2=0Ω and R1=332Ω in the circuit shown, the average group-delay variation over the filter bandwidth is about 25 nsec. Raising R2 to 31.6Ω and lowering R1 to 301Ω decreases the variation to approximately 15 nsec, and setting R2=59Ω with R1=274Ω decreases it to approximately 7 nsec. The last case has a less-than 0.5-dB effect on band-edge selectivity but does not change the filter's 3-dB bandwidth (Figure 3).
Is this the best Design Idea in this issue? Select at www.edn.com.
-
please i am a young man studing at a university i am i want to build a circuit which is about electricity which is if light shoould come to a house, the light should stay for a specified period of given time before the house to ave a light.I will be gratefull if a circuit is design for me
muhammad - 2007-11-8 12:48:00 PDT
