Square-wave modulator has variable frequency and pulse width

A few years ago, I worked at a disk-drive company. We had a plating facility that required square waves to drive the high-voltage plating operation. The challenge was that the square wave's pulse width had to be variable, along with the duty cycle. Also, the amplitude of the pulses had to be adjustable. The circuit in Figure 1 satisfies all these criteria. The circuit delivers a unipolar (adjustable from 0 to 12V) pulse with adjustable frequency and pulse width. The first half of a dual, retriggerable monostable multivibrator, IC_1A, generates the frequency of the pulse train. The 100-kΩ potentiometer, R₁, along with R₂ and C₁, sets the adjustable frequency. R₃, R₄, and C₂ set the adjustable pulse width in the second section of the multivibrator, IC_1B. The ac-coupled op amp, IC_2A, running open-loop, delivers a ±12V pulse output. D₁ and D₂ clamp the negative-going excursions of the pulse train to ground. The other half of the op amp, IC_2B, serves as a level shifter that allows amplitude control over the range 0 to 12V. You can modulate the amplitude at low frequency by varying the amplitude-control voltage.

Is this the best Design Idea in this issue? Select at www.edn.com.