EDN's technical editors highlight notable new products including analog and digital ICs, power components, sensors, passives, boards and systems, software, and more. To submit products for consideration, please see the information on our Editorial Opportunities page.
Profile
RSS Feed
-
Add this blog to your RSS newsreader!
Recent Posts
- International Resistive Company SC-3: Chip resistor doubles maximum voltage rating
- AVX Corp MLC: Chip capacitor targets tip-and-ring-telecom applications
- Vishay Intertechnology VPR221Z: Z-Foil resistor claims near-instantaneous thermal stabilization
- Diodes Inc AP6714 and AP6015: Buck and boost converters guard against high inrush current and output-voltage overshoot
- Aimtec AM12T-Z and AM12TW-Z: Converters provide regulated single and dual outputs
- Maxim Integrated Products DS2726: Stand-alone protection IC integrates cell balancing
- Phihong POE36U-1AT: Single-port midspan adapter suits a range of applications
- Summit Microelectronics SMB339: Battery-charger IC adapts to individual power sources
- Power-One SSQE48T25033: Sixteenth-brick converter provides 3.3V at 25A
- AMD ATI Radeon HD 4650 and HD 4670: Graphics cards feature 320 stream-processing cores
Recent Comments
- inverter-china.com on Belden: VFD cables channel power from ac-drive systems to ac motors
- williams on AVX Corp MLC: Chip capacitor targets tip-and-ring-telecom applications
- Vincent Rheaume on Diodes Inc AP6714 and AP6015: Buck and boost converters guard against high inrush current and output-voltage overshoot
- Jake on Western Digital My Book World Edition II: Digital-shared-storage device has a 1-Tbyte capacity
- Convert on American Power Conversion InfraStruxure InRow RP: Cooling unit comes in chilled-water and refrigerant-based designs
Most Commented On
- International Rectifier IRF6716M and IRF6712S: DirectFET MOSFET chip set has a low on-resistance (5)
- SunaptiCAD VeriLogger Extreme: Verilog 2001 simulator provides faster RTL and gate-level simulations (5)
- Conexant Systems CX25850, CX25851, and CX25853: Eight-channel video decoder aims at security and surveillance applications (4)
- Coridium Corp ARMmite: Development and wireless-connectivity board supports Bluetooth and Zigbee protocols (4)
- Zuken CR-5000: Free simulation kit for PCBs using Altera’s Arria FPGAs (3)
Archives
- November 2008
- October 2008
- September 2008
- August 2008
- July 2008
- June 2008
- May 2008
- April 2008
- March 2008
- February 2008
- January 2008
- December 2007
- November 2007
- October 2007
- September 2007
- August 2007
- July 2007
- June 2007
- May 2007
- April 2007
- March 2007
- February 2007
- January 2007
- December 2006
- November 2006
- October 2006
- September 2006
- August 2006
By Category
- Analog (59)
- Analog Design (47)
- Applied System Design (88)
- Communications/Network Design (5)
- Components, Hardware, Interconnect (212)
- Components/New Products (11)
- Consumer Electronics Design (83)
- Digital ICs (42)
- EDA (16)
- Embedded Systems (110)
- IC Design (13)
- Peripherals (73)
- Power Management (93)
- Power Sources/Controllers (116)
- Processor-based Design (38)
- Processors & Tools (59)
- Test & Measurement (28)
- Test and Measurement (39)
Components/New Products Articles
- EDN on Components: LED flashlight, new products, more...
- Linear wind-power meter compensates for temperature
- Circuits drive single-coil latching relays
- EDN on Components: Compact fluorescent lights, 3-D printer, more...
- Compact fluorescent lights: Not always the best solution
- More...
Blog
Thursday, October 2, 2008
Lumex OctoLEDs: Surface-mount LEDs replace through-hole devices
Oct 2 2008 2:16PM | Permalink | Email this | Comments (0) |
Blog This! using: Blogger.com | LiveJournal |
Digg This | Slashdot This | add to Del.icio.us
Combining surface-mount technology with the capabilities of through-hole, leaded T-5-mm epoxy lens LEDs, the OctoLED features 7000-mcd brightness levels. Replacing the 5-mm standard through-hole LEDs, the devices measure 6×6×11 mm and come on 24-mm tape for automatic insertion. Available in a range of colors, including red, yellow, green, blue, and white, the LEDs also come in bicolor and RGB versions. The devices also include a variety of lens finishes, allowing different viewing angle options, varying depending on lens type. The ROHS (restriction-of-hazardous-substances)-compliant LEDs can withstand 225°C soldering temperatures for 10 seconds, with a recommended 2°/sec gradual temperature rise reaching 150°C. Prices for the OctoLEDs start at 30 cents, based on color specification.
Lumex, www.lumex.com
Related entries in: Components, Hardware, Interconnect |
Post a comment
About Us | Contact Us | Free Email Newsletters | Free Magazine Subscription | Advertising | 
RSS
©1997-2008 Reed Business Information, a division of Reed Elsevier Inc. All rights reserved.
Use of this Web site is subject to its Terms of Use | Privacy Policy