Skip navigation
Subscribe to EDN
« Achieving stability with power op amps | Main | Bias JFET with a diode in the source leg »
Paul Rako
Paul Rako

RF shielding injection-molded plastic

December 31, 2008

The always-great Conformity magazine has a nice article about shielding injection-molded plastics. It is written by a guy whose company does the shielding, so that that into account when you read it.

Posted by Paul Rako on December 31, 2008 | Comments (0)
POST A COMMENT
Display Name
captcha

Before submitting this form, please type the characters displayed above. Note the letters are case sensitive:

Advertisement
Advertisement
Advertisement
About EDN   |   Site Map   |   Contact Us   |   Subscription   |   RSS
© 2012 UBM Electronics. All rights reserved.
Use of this Web site is subject to its Terms of Use | Privacy Policy

Please visit these other UBM Canon sites

UBM Canon | Design News | Test & Measurement World | Packaging Digest | EDN | Qmed | Pharmalive | Appliance Magazine | Plastics Today | Powder Bulk Solids | Canon Trade Shows