Reference stabilizes exponential current

In an antilog converter, the difference between the base voltages of two transistors sets the ratio of their collector currents:

The use of matched transistors balances the first-order temperature coefficient but leaves a temperature-dependent gain term, q/kT. Classic antilog circuits use a thermistor in the drive circuitry to correct this temperature dependency. However, if the control input is a fraction of some reference voltage, as when you use a manual potentiometer or a DAC, you can achieve an exact temperature correction by adding a second reference transistor. Figure 1 shows three of the five transistors in a CA3046 array. Q₁ is the exponential current source, and Q₂ is the conventional reference transistor. IC₂ forces Q₂'s collector to ground so its collector current, 1 mA in this example, is simply the reference voltage divided by R₃. Typically, this current equals the maximum output required from Q₁; lower currents result from negatively driving the transistor's base.

Is this the best Design Idea in this issue? Vote at www.ednmag.com.