Advertisement
Advertisement

EDN Access--06.05.97 Schmitt trigger has dynamic threshold

-June 05, 1997


 
June 5, 1997

Schmitt trigger has dynamic threshold
Isaac Eng, GSI Inc, Ottawa, ON, Canada

Schmitt triggers usually switch only at predefined static setpoints. For example, to allow user-defined setpoints, you can use a comparator in a standard hysteresis configuration (Figure 1). However, the design in Figure 2 allows dynamic setpoints, which are beneficial for variable-noise applications. This circuit is useful for rejecting noise that fluctuates in amplitude.

The circuit in Figure 2 has a low component count and uses common parts. VLO and VHI are the low and high setpoints, respectively, which you can change dynamically. VIN drives the negative input of comparator LM311, which compares this signal to the noninverting input voltage that comes from the output of the CD4053 analog multiplexer. The multiplexer's output voltage (active threshold) switches depending on the state of VOUT, just as in a regular Schmitt trigger. VCC and VEE can be 5V and -5V, respectively. (DI #2030)

Figure 1
This Schmitt trigger uses a comparator in a standard hysteresis configuration and has static setpoints.
Figure 2
You can dynamically set the high and low thresholds of this Schmitt trigger.


| EDN Access | Feedback | Table of Contents |

Copyright c 1997 EDN Magazine, EDN Access . EDN is a registered trademark of Reed Properties Inc, used under license. EDN is published by Cahners Publishing Company , a unit of Reed Elsevier Inc.

 

 

Loading comments...

Write a Comment

To comment please Log In

FEATURED RESOURCES